Horizon Fitness PST6, PST8 8, 9, PRE-ASSEMBLY, ASSEMBLY STEP 1, ASSEMBLY STEP 2

BEFORE

YOU BEGIN

8

INTRODUCTION IMPORTANT

PRECAUTIONS ASSEMBLY BEFORE

YOU BEGIN TREADMILL

OPERATION LIMITED

WARRANTY

TROUBLESHOOTING

& MAINTENANCE

CONDITIONING

GUIDELINES

BEFORE

YOU BEGIN ASSEMBLY

9

INTRODUCTION

IMPORTANT

PRECAUTIONS

TREADMILL

OPERATION

CONDITIONING

GUIDELINES

TROUBLESHOOTING

& MAINTENANCE

LIMITED

WARRANTY

A Open HARDWARE BAG 1.

B Connect CONSOLE WIRES.

C Slide CONSOLE MASTS over BASE

FRAME BRACKETS.

D Insert BOLT (A) and FLAT WASHER

(B) into bottom side hole and

attach with NUT (C).

E Insert BOLT (D) and FLAT WASHER

(B) into rear hole.

F Repeat on other side.

G Insert BOLT (D) and FLAT WASHER

(B) into top side hole.

H Insert BOLT (D) into rear-most

inside hole.

I Repeat on other side.

NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to

prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and

partially threaded in before completely tightening any ONE bolt.

PRE-ASSEMBLY

��

ASSEMBLY STEP 1

��

HARDWARE BAG 1 CONTENTS :

��

Steps A-C

Steps D-F

Steps G-I

A Open HARDWARE BAG 2.

B Slide CONSOLE MAST BOOTS

down over BASE FRAME.

C Lift RUNNING DECK to upright

position.

D Insert 4 SCREWS (E) into inside

holes of CONSOLE MAST BOOTS.

E Connect CONSOLE WIRES.

F Slide CONSOLE BRACKETS into

CONSOLE MAST as shown.

G To attach CONSOLE, insert

1 FLAT WASHER (F), 1 LOCK

WASHER (G) and 1 BOLT (D) into

all 6 holes on upper CONSOLE

MASTS.

ASSEMBLY STEP 2

��

HARDWARE BAG 2 CONTENTS :