INTRODUCTION IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
A S S E M B LY STEP 3
HARDWARE BAG 3 CONTENTS :
BOLT (F) | SPRING WASHER (C) | FLAT WASHER (D) |
25 mm | 15 mm | 15 mm |
Qty: 4 | Qty: 4 | Qty: 4 |
CONSOLE |
|
FLAT WASHER (D) | CONSOLE CABLE |
| |
SPRING WASHER (C) |
|
BOLT (F) | DO NOT ATTACH |
| THIS SIDE UNTIL STEP |
LEFT CONSOLE MAST
A Open HARDWARE BAG 3. |
B With running deck in lowered position, place console on the console masts. Align the |
A S S E M B LY STEP 3 ( C O N T I N U E D ) |
|
STEP D | STEP E |
CONSOLE CABLE COVER |
|
| CONSOLE |
| BOARD |
| CONSOLE |
| CABLE |
CABLE TIE |
|
STEP F |
|
CABLE TIE | CONSOLE CABLE COVER |
|
A S S E M B LY STEP 4
HARDWARE BAG 4 CONTENTS :
SCREW (I) 15 mm Qty: 2
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE
brackets that are underneath the console with the top holes of the console masts. |
C To assemble the CONSOLE to the left CONSOLE MAST, insert 1 BOLT (F), |
1 SPRING WASHER (C) and 1 FLAT WASHER (D) into the 2 holes in the |
left CONSOLE mast and lightly tighten. |
D Locate CONSOLE CABLE COVER on back of CONSOLE and remove. |
E Attach CONSOLE CABLE to CONSOLE BOARD. NOTE: Do not pinch CONSOLE CABLE. |
F Replace CONSOLE CABLE COVER on back of CONSOLE and attach excess wire to CABLE TIE. |
DECK
LOCK
LATCH
SCREWS (I) 
LEFT HANDLEBAR 
WATER BOTTLE |
HOLDER |
TROUBLESHOOTING CONDITIONING MAINTENANCE GUIDELINES
LIMITED
WARRANTY
10
G Repeat step C above to assemble the right console mast to the console. |
Note: Do not completely tighten any screws or bolts until step 5 is complete!
AOpen HARDWARE BAG 4.
BAttach DECK LOCK LATCH to LEFT HANDLEBAR using 2 SCREWS (I).
CSlide the WATER BOTTLE HOLDER down into the hole in the CONSOLE and snap together.
11
LIMITED WARRANTY &
T90_Rev.1.5.indd | 9/10/08 4:21:04 PM |
