8
INTRODUCTION IMPORTANT
PRECAUTIONS ASSEMBLY BEFORE
YOU BEGIN TREADMILL
OPERATION LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
PRE-ASSEMBLY ASSEMBLY STEP 2ASSEMBLY STEP 1Open HARDWARE BAG 2.
Slide the left CONSOLE MAST
down onto the CONSOLE MAST
SUPPORT TUBE. Bolt in place
using 2 BOLTS (B), 2 SPRING
WASHERS (C), and 2 FLAT
WASHERS (D) on the side. Then,
bolt in place using 2 BOLTS (B),
2 SPRING WASHERS (C), and 2
ARC WASHERS (E) on the front.
Repeat on the other side.
Note: On RIGHT CONSOLE MAST,
the CONSOLE WIRE must be
threaded through the mast.
A
B
C
BOLT (B)
15 mm
Qty: 8
SPRING WASHER (C)
15 mm
Qty: 8
FLAT WASHER (D)
15 mm
Qty: 4
ARC WASHER (E)
17 mm
Qty: 4
HARDWARE BAG 2 CONTENTS :
NOTE: Be careful not to pinch any wires
while assembling the masts.
RIGHT CONSOLE MAST
CONSOLE MAST
SUPPORT TUBE
BOLT (B)
SPRING WASHER (C)
FLAT WASHER (D)
BOLT (B)
SPRING WASHER (C)
ARC WASHER (E)
CONSOLE CABLE
(THREAD THROUGH
INSIDE HOLE IN MAST)
Open HARDWARE BAG 1.
Slide the left frame extension
tube onto the console mast
support tube. Bolt in place
using 2 BOLTS (A) on the side.
Repeat on the other side.
A
B
C
BOLT (A)
15 mm
Qty: 4
HARDWARE BAG 1 CONTENTS :
FRAME EXTENSION TUBE
CONSOLE MAST SUPPORT TUBE
BOLTS (A)
NOTE: Do not completely tighten any
screws or bolts until step 5 is complete!
T90_Rev.1.5.indd 8-9 9/10/08 4:21:01 PM