H. Startup
WARNING
1.All parts are
2.If the icemaker is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the compressor.
3.At startup, confirm that all internal and external connections are free of leaks.
1)Open the water supply line
2)Remove the front panel. Move the control switch on the control box to the "ICE" position, then move the power switch to the "ON" position. Replace the front panel in its correct position, then turn on the power supply to start the automatic icemaking process.
3)Once the icemaker starts to produce ice, allow it to run for another 30 minutes.
4)Turn off the power supply, then remove the front panel.
5)Move the control switch to the "DRAIN" position, then replace the front panel in its correct position. Turn on the power supply and allow the water system to drain for 5 minutes.
6)Confirm bin control operation:
a)Turn off the power supply, then remove the front and top panels.
b)Move the power switch to the "OFF" position.
c)Remove the strap connecting the spout to the chute assembly. See Fig. 5. Pull up the chute assembly slightly so that you can access the actuator located in the top of the chute.
d)Move the control switch to the "ICE" position, then move the power switch to the "ON" position.
e)Turn on the power supply to start the automatic icemaking process.
WARNING! Keep hands, hair, and loose clothing clear of the cutter and auger on top of the evaporator assembly. Allow the icemaker to run until the compressor starts (approximately 60 seconds).
f)Press and hold the actuator paddle located in the top of the chute. The icemaker should shut down within 6 seconds.
Bin Control Assembly
Proximity
Switch
Strap | Actuator |
|
Spout
Strap
Chute | Fig. 5 |
Assembly |
|
13
