H. Startup
CAUTION
1.All parts are
2.If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the Compressor.
3.To prevent damage to the Water Pump, do not leave the Control Switch in the “SERVICE” position for extended periods of time when the Water Tank is empty.
1)Open the Water Supply Line
2)Remove the Louver.
3)Move the Control Switch on the Control Box to the “ICE” position.
4)Turn on the power supply and allow the icemaker to operate for 5 minutes to fill up the
Water Tank. | Control Box |
5)Move the Control Switch to the “SERVICE” position. Move the Service Switch to the “WASH” position.
6)Allow the icemaker to run for 5 minutes.
7)Move the Service Switch to the “DRAIN” position.
8)Allow the icemaker to drain for 2 minutes.
9)Turn off the power supply.
10)Move the Control Switch to the “ICE” position.
11)Replace the Louver in its correct position.
12)Clean the Storage Bin using a neutral cleaner. Rinse thoroughly after cleaning.
13)Turn on the power supply to start the automatic icemaking process.
ICE | Control Switch |
OFF |
|
SERVICE | Service Switch |
WASH |
|
CIRCULATE |
|
DRAIN |
|
Fig. 6
13
