1.2 TECHNICAL DATA
ENERGY CONSUMPTION ventilated oven only function (CENELEC HD 376 norms) |
|
To reach 200°C | 0,35 kWh |
To maintain a temperature of 200°C for an hour | 1,15 kWh |
Total consumption | 1,5 kWh |
• OUTPUT POWER - MICROWAVE: 1000 W (IEC705) |
|
For additional data, consult the data plate placed on the front side of the appliance.
This appliance complies to E.E.C. directive no. 89/336 and 92/31 regarding Electromagnetic Compatibility, and to directive 89/109/E.E.C. regarding materials which come into contact with food.
OUTPUT POWER
ONLY FOR SOME MODELS: The microwave output power is also indicated inside this simbol, placed on the door.
(ONLY FOR U.K.) The letter indicates the heating category to which your oven belongs: some
1.3 INSTALLATION AND ELECTRICAL CONNECTION
1)Remove all the accessories and wash them.
2)Clean the inside with a soft, damp cloth.
3)Check that there is no damage as a result of transportation, and in particular that the door opens and closes properly.
4)Place the support (I) in the centre of the circular groove and fix the turntable (H) to it. The spindle (D) should be inserted in the corresponding groove in the centre of the turntable (see page 5).
5)The appliance is already fitted with a plug and may only be connected to a correctly installed earthed socket. Only a qualified electrician may install or relocate a socket outlet.
The plug must be easily accessible after installation unless an isolator switch is used to disconnect all poles having a contact gap of at least 3mm in each pole.
6)Before use, check that the power supply voltage is the same as the one shown on the rating label and that the power outlet is properly earthed: the manufacturer disclaims any liability in the event of
ELECTRICAL CONNECTION (U.K. ONLY)
A)If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after
removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse.
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green and yellow: | Earth | E |
| ||
Blue: | Neutral | L |
Brown: | Live | N |
|
If the plug is a
B)If your appliance is not fitted with a plug, please follow the instructions provided below:
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The green and yellow wire must be connected to the terminal in the
plug marked with the letter E or the earth symbol or coloured green or green and yellow.
The blue wire must be connected to the terminal marked with the letter N or coloured black.
The brown wire must be connected to the terminal marked with the letter L or coloured red.
10