Maintenance and Care
Switching off the electricity | Empty the Water Container after each cycle |
GB Unplug the dryer when not using it, when cleaning it, and during maintenance activities.
Pull the container out of the dryer and empty it into a sink
or other suitable drain. Replace container securely. GB Always check and empty the container before you start a
new drying programme.
Clean the filter after each cycle
The filter is an important part of your dryer: it accumulates lint and fluff that is formed while drying.
When finished drying, clean the filter by rinsing it under running water or with your vacuum cleaner. Should the filter become clogged up, the airflow inside the dryer will be seriously compromised: drying times lengthen and you will consume more energy. It may also damage your dryer. The filter is found in front of the dryer trim (see diagram). 
Removing the filter:
1. Pull the plastic grip of the filter upwards (see diagram). 2. Open the filter by
depressing the clip.
3. Clean the lint from the inside of the filter, and
replace it correctly. Ensure the filter is fully located flush into the tumble dryer trim.
Do not use dryer without replacing the filter.
Check the drum after each cycle
Turn the drum manually in order to remove small items (handkerchiefs) that could have been left behind.
Cleaning the drum
Do not use abrasives, steel wool or stainless steel cleaning agents to clean the drum.
A coloured film may start to appear on the stainless steel drum, this may be caused by a combination of water and, or cleaning agents such as fabric conditioner from the wash. This coloured film will not affect the dryer performance.
Water Contaniner
Condenser Unit
Catches
Handle
Cleaning the Condenser Unit
•Periodically (every month) remove Condenser unit and clean any build up of fluff from between the plates by
rinsing it under the tap with cold water. This should be done with cold water from the rear of the condenser.
To remove condenser :
1.Unplug the dryer and open the door.
2.Pull open the condenser cover (see diagram), release the three catches by turning 90° counter clockwise then pull on the grip and remove from dryer.
3.Clean the surface of the seals and replace with the arrows pointing upwards making sure that the catches have been secured.
Cleaning the dryer
•External parts in metal or plastic and rubber parts can be cleaned with a damp cloth.
•Periodically (every 6 months) vacuum the front Air intake grille and Vents at the rear of the dryer, to remove any build up of fluff, lint or dust. Also to remove accumulation of fluff from the front of condenser and filter areas, clean occasionally with a
vacuum cleaner.
Do not use solvents or abrasives.
Your dryer uses special bearing components which do not need lubrication.
Have your dryer checked regularly by authorized technicians to ensure electrical and mechanical safety (see Service).
Filter
Tap
Rear
Condenser Unit
Air Intake
Front
Condenser Cover
16
