Dryer Description
To open door
Pull on handle
Condenser unit (cover open)
Control Panel
On/Off Button & Light | Indicator |
|
The Features
Rating | GB |
Plate |
|
Water |
|
container | Model & |
| |
| Serial |
Filter | Numbers |
|
Air Intake
Grille
|
|
|
|
|
|
|
|
| Condenser | |
|
|
|
|
|
|
|
|
| cover handle | |
|
|
|
|
|
|
|
|
| (Pull to open) | |
|
|
| ECO Light | Start/Pause Button & | Child Lock | |||||
|
|
|
|
|
|
|
| |||
Display Panel | Light | |||||||||
Button & Light | ||||||||||
| ||||||||||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
Programme Knob | Option Buttons and Lights | Clean | Empty Water | Programme |
| Condenser | Clean Filter | Progress Light | |
|
| Light | Light |
|
The On/Off button/ light 
, if the dryer is running and this button is pressed the dryer is turned off. The light signals that your dryer is in use or ready to select a programme.
The Programmes knob sets the programme: rotate until the indicator is pointing to the programme you want to select (see Start and Programmes).
The Option buttons/ lights select available options for your selected programme. The lights indicate that the option
has been selected (see Start and Programmes).
The Display Panel has three sections: Sensor Dry = Drying level, Timed dry = Drying time and Time to End / Delay start each with a corresponding selection button (see The Display).
START/PAUSE button with indicator light 
: when the green indicator light flashes slowly, press the button to start the programme. When the cycle has started, the indicator light is illuminated in a fixed manner. To pause the programme, press the button again; the indicator light will turn orange and begin to flash again.
To restart the programme from the point at which it was interrupted, press the button again (see Start and Programmes).
The Programme Progress Lights indicate each state of the programme by turning on as appropriate.(see Start and Programmes).
The Empty Water indicator “H2O” signals that the water container should be emptied. The light will take a few seconds to go out after replacing the empty water container; the dryer must be running for this to happen (see The Controls).
Note: if the water bottle is full the display shows “H2O” and the 
indicator flashes, the heat is turned off and your clothes will not dry.
The Empty Water Clean Filter Light 
gives a reminder before every programme, that its essential to clean the filter and empty the water container every time the dryer is used (see Maintenance and Care).
The Clean Condenser Light 
gives a reminder, that its essential to clean the condenser at regular intervals (see Maintenance and Care).
The Child Lock button/light 
Press and hold this button after selecting your programme and any options. This prevents the programme settings from being changed. When the light is lit the other buttons and programme knob are disabled. Hold the button to cancel and the light will go out.
ECO Light - this light is illuminated as you select options that use less energy (see the controls).
5
