Important Information
For your Condenser dryer to operate efficiently, you must follow the regular maintenance
GB schedule shown below:
Fluff Filter – You MUST Clean the fluff filter after every drying cycle.
Step 1
Open the door of your dryer.
Step 2
Pull out the filter (using the two finger grips).
Step 3
Open the filter by releasing the clip.
Step 4
Clean any fluff deposits from the inside surface of the filter mesh.
Step 5
Refit the filter – Never run the dryer without a filter.
Failure to clean the filter after every drying cycle will affect the drying performance of your machine – It will take longer to dry and as a result will use more electricity during drying.
Water Container – You must empty the water container after every drying cycle.
Step 1
Pull the water container towards you and remove it fully from the dryer.
Step 2
Empty the Water from the
Container.
Step 3
Refit the Water Container ensuring that it is pushed fully back into position...
Failure to empty the Water Container will result in:
-The machine will stop heating (so the load may be wet at the end of the cycle).
-The ”Empty Water” light will flash to tell you that the Container is full.
The water bottle/clean
filter light comes on when you select a programme to remind you to make sure that the water bottle is empty and that the filter is clean before starting a new cycle’
Priming the Water Collection System
When your dryer is new, the Water Container will not collect Water until the system is primed, this will take 1 or 2 drying cycles. Once primed it will collect Water during every cycle.
2
