INSTALLATION INSTRUCTIONS
UNPACKING THE COOKER
Unpack the components from inside the grill and oven. Check that the following parts are present:
Grill pan and grid Baking dish
Main oven shelves (2) Top oven/grill shelf (1) Aluminium burner bodies (4)
Top oven/grill shelf heat shield Pan supports
Enamelled burner caps (4) Literature
LEVELLING
Four skid feet are fitted which can be adjusted up or down to level the cooker.
CONVERSION FOR USE ON BUTANE (G30) OR PROPANE (G31)
Each burner requires the injector to be replaced and bypass screws adjusted or replaced as follows:
1.Remove the loose hotplate burner parts.
2.Using a 7mm socket, replace the hotplate injectors as appropriate (see table on previous page).
3.
4.Remove the enamelled baffle at the front of the grill (2 screws).
5.Remove the screw on the right hand side of the burner and gently slide the burner off the injector.
6.Using a 7mm socket, replace the grill injector as appropriate (see table on previous page).
7.
8.Inside the top oven, remove the central screw securing the burner retainer. Slide the retainer to the right slightly and lift away.
9.Lift the burner assembly and place on the floor of the oven to the right of the burner opening.
10.Using a 7mm socket, replace the oven injector as appropriate (see table on previous page).
12.Replace the main oven injector following the same procedure as for the top oven.
13.From behind the cooker, remove the screws securing the rear panel and swing the left hand side outwards (viewed from the rear) to gain access to the main oven flame supervision device.
14.Replace the flame supervision device bypass screw.
16.Carefully pull off the control knobs and timer buttons.
17.Remove the 2 screws securing the underside of the control panel. Slide the control panel to the left slightly to remove.
18.Remove the 6 screws securing the timer mounting panel. Without completely removing it, manoeuvre the timer mounting panel to gain access to the thermostat bypass screws.
19.Using a narrow flat bladed screwdriver rotate the bypass screws fully clockwise. The main oven thermostat bypass screw is located on the body of the thermostat below the spindle, the top oven thermostat bypass screw is located on the body of the thermostat to the right of the spindle and the hotplate tap bypass screws are located down the centre of the spindle.
21.Secure the
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
9
