Practical advice on using the appliance
!Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. Use a magnet to test the compatibility of the cookware.
SUITABLE | UNSUITABLE |
* | Copper, |
Cast iron | |
Enamelled steel | Aluminium, Glass, Earthenware, |
Special stainless steel | Ceramic, non magnetic Stainless steel |
In addition, to obtain the best results from your hob:
•Use pans with a thick, flat base in order to fully utilise the cooking zone.
•Always use pans with a diameter which is large enough to cover the hotplate fully, in order to use all the available heat.
•Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware.
•Avoid using the same cookware which has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, causing it not to adhere correctly.
Safety devices
Pan sensor
Each cooking zone is equipped with a pan sensor device. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. If the indicator light is flashing, it may indicate:
•An incompatible pan
•A pan whose diameter is too small
•The pan has been removed from the hotplate.
Overheating protection |
| |||
GB | ||||
If the electronic elements overheat, the hob switches | ||||
off automatically and F appears on the display, |
| |||
| ||||
followed by a flashing number. When the temperature |
| |||
has reached a suitable level, this message disappears |
| |||
and the hob may be used again. |
| |||
Safety switch |
|
|
| |
The appliance has a safety switch which automatically |
| |||
switches the cooking zones off after they have been in |
| |||
operation for a certain amount of time at a particular |
| |||
power level. When the safety switch has been |
| |||
triggered, the display shows “0”. |
| |||
For example: the right rear hotplate is set to 5 and will |
| |||
switch off after 5 hours of continuous operation, while |
| |||
the front left hotplate is set to 2 and will switch off after |
| |||
8 hours. |
|
|
| |
|
|
|
| |
Power level | Maximum operating time in hours |
|
| |
|
|
|
| |
1 | 9 |
|
| |
|
|
|
| |
2 | 8 |
|
| |
|
|
|
| |
3 | 7 |
|
| |
|
|
|
| |
4 | 6 |
|
| |
|
|
|
| |
5 | 5 |
|
| |
|
|
|
| |
6 | 4 |
|
| |
|
|
|
| |
7 | 3 |
|
| |
|
|
|
| |
8 | 2 |
|
| |
|
|
|
| |
9 | 1 |
|
| |
|
|
|
| |
Buzzer
This can also indicate several irregularities:
•An object (a pan, cutlery, etc.) has been placed on the control panel for more than 10 seconds.
•Something has been spilt on the control panel.
•A button has been pressed for too long. All of the above situations may cause the buzzer to sound. Remove the cause of the malfunction to stop the buzzer. If the cause of the problem is not removed, the buzzer will keep sounding and the hob will switch off.
8
