Fixing

The appliance must be installed on a perfectly level supporting surface.

Any deformities caused by improper fixing could affect the features and operation of the hob.

The thickness of the supporting surface should be taken into account when choosing the length of the screws for the fixing hooks:

30 mm thick: 17.5 mm screws

40 mm thick: 7.5 mm screws

Fix the hob as follows:

1.Use short flat-bottomed screws to fix the 4 alignment springs in the holes provided at the central point of each side of the hob.

2.Place the hob in the cavity, make sure it is in a central position and push down on the whole perimeter until the hob is stuck to the supporting surface.

3.For hobs with raised sides: After inserting the hob into its cavity, insert the 4 fixing hooks (each has its own pin) into the lower edges of the hob, using the long pointed screws to fix them in place, until the glass is stuck to the supporting surface.

Single-phase connection

GB

The hob is equipped with a pre-connected electricity supply cable, which is designed for single-phase connection. Connect the wires in accordance with the instructions given in the following table and diagrams:

Voltage and

 

Electrical cable

Wire connection

mains frequency

 

 

 

 

230-240V 1+N ~

 

 

: yellow/green

 

 

N: the two blue wires together

220-240V 1+N ~

 

 

 

 

L: brown and black together

50/60 Hz

 

 

 

 

 

 

Other types of connection

If the mains supply corresponds with one of the following:

Voltage and mains frequency

400V - 2+N ~ 50/60 Hz

220-240V 3 ~ 50/60 Hz

230-240V 3 ~ 50/60 Hz

400V - 2+2N ~ 50/60 Hz

Separate the wires and connect them in accordance with the instructions given in the following table and diagrams:

!The screws for the alignment springs must remain accessible.

!In order to adhere to safety standards, the appliance must not come into contact with electrical parts once it has been installed.

!All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool.

Electrical connection

Voltage and

Electrical cable

mains frequency

 

400V - 2+N ~

50/60 Hz

230-240V 3 ~

220-240V 3 ~

50/60 Hz

400V - 2+2N ~

50/60 Hz

Wire connection

: yellow/green;

N: the two blue wires together

L1: black

L2: brown

: yellow/green;

N1: blue

N2: blue

L1: black

L2: brown

!The electrical connection for the hob and for any built-in oven must be carried out separately, both for safety purposes and to make extracting the oven easier.

If the mains supply corresponds with one of the following:

Voltage and mains frequency

400V 3 - N ~ 50/60 Hz proceed as follows:

Terminal board

UNDERSIDE OF HOB

On the lower part of the appliance there is a connection box for the different types of electricity supply (the picture is only an indication and is not an exact representation of the purchased model).

!The cable provided is not suitable for the following types of installation.

1.Use a suitable supply cable, H05RR-F or higher, with the right dimensions (cable cross section: 25 mm).

2.To open the terminal board, use a screwdriver as a lever under the side tabs of the cover (see

Terminal board picture).

3.Loosen the cable clamp screw and the terminal board screws in accordance with the type of

3

Page 3
Image 3
Hotpoint CRA manual Electrical connection, Fixing, Single-phase connection, Other types of connection, Terminal board