EXPANDING YOUR DECT SYSTEM
Pico cellular system
Your DDP-700MINI DECT cordless phone can be configure as a pico-cellular system by adding more base placed in different locations. This will extend your handset mobility. This application can be implemented in the office or factory. If you configure your DECT system to operate in pico-cellular, you should see to it that the placement of base unit will be optimized to cover the entire location where you intend to use your DDP-700handset.
The following should be observed :
1.Register another base/s (another DDP-700base or another DECT GAP compatible) to your DDP-700hand set.
2.Place these base in the location where you intend to operate your handset, place them to cover all area without dead spot, this means that each base station is within the range of each other base. Please see figure below :
B
A
C
D
3.Your DDP-700however cannot establish a seamless handover (handover means the transfer of call-connec tion from the range of location A to location B, please see figure above). The handover from location A to
be takes about 2 seconds or more. Thus, when you are on call progress on location D and moving to location C, your DDP-700will warn you (if out of range warning is set to on-see warning tone) of out of range from location D. If you move closer to location C, your DDP-700handset will lost connection and call will be cut off. If you move further to location C, your DDP-700handset will be connected to the base located at C.
