Installation and fastening
The following instructions are provided for qualified install- ers so that they may accomplish installation, adjustment and technical maintenance operations correctly and in compliance with current regulations and standards.
Important: before any operation, disconnect the hob from the electrical supply.
Fastening
Very important: The installation of a glass ceramic hob must be carried out on a
Installation
•The hob should be installed on a piece of kitchen furniture simply by removing the corresponding space.
•The material used for the working surface must be able to resist a temperature of approximately 100°C
•The hob must be positioned at a minimum distance of 40mm from the back wall or from any other vertical surface, to allow for adequate aeration and to prevent the surfaces surrounding the appliance from overheat- ing.
•If you want to install the hob on top of an oven, the latter must come with a forced ventilation cooling sys- tem.
•Try to avoid installing the hob on a dishwasher; if you have to do this, place a waterproof separating ele- ment between the two appliances.
The fastening springs are screwed on with screws (see diagram).
It is essential that these screws are always accessi- ble.
Insert the hob in the space provided in furniture unit, ex- ercising suitable pressure on the entire perimeter so that the hob sticks perfectly to the top.
REAR SPRING ASSEMBLY
FRONT OF HOB
KITCHEN | 30 |
| 40 |
WORKTOP |
| ||
|
|
|
|
|
|
|
|
48
560 | +/- |
| |
| 1 |
590 |
|
|
| 574 |
|
|
| 48 |
|
|
|
| 520 |
|
|
| 504 |
| 1 |
|
|
| 1 |
| - |
|
|
| - |
490 | +/ | 560 |
| 490 | +/ |
| +/- |
| |||
|
|
| |||
|
|
| 1 |
|
|
10
Distance to keep between the
the cabinet
HOB FROM BELOW
The length of the adjusting screw of the fastening hooks must be set before they are assembled, in according to the thickness of the top and to the following table:
| H | |
|
|
|
h Top = 30mm |
| h Top = 40mm |
|
|
|
17,5 mm |
| 7,5 mm |
|
|
|
5