Hotpoint FFU00 manual Installation, Connection of Water Filter

Models: FFU00

1 28
Download 28 pages 4.59 Kb
Page 9
Image 9
●Connection of Water Filter:

Installation

Connection of Water Filter:

*Now you have to cut the pipe to the length it needs to be to run from the back of the appliance and attach to the water filter.

NOTE: The water filter is marked with an arrow to show the direction of water flow (ie. from supply tap to appliance).

Remember however, that the connection process is being done FROM the appliance TO the tap (ie. in reverse of the water flow when in use).

 

 

 

 

Note the direction markings on the filter

 

* Repeat on the other end of the water

* Unscrew the threaded connector and

 

filter, using the remainder of water

 

pipe (Fig.E)

place it over the end of the cut

 

 

 

 

section of pipe coming away from

 

* Run this section of water pipe from

the appliance. Push the pipe over the

 

 

the water filter to the water supply

end of the water filter that the arrow

 

 

tap, making sure it is not trapped or

points to and tighten the threaded

 

 

kinked at all.

connector (Fig.D)

 

 

 

 

Connection to the Water Tap:

*Cut the pipe that is connected to the water filter to the correct length. Again, make sure that the cut is nice and square to avoid leaks.

*Push the pipe into the smaller hole of the connector supplied in the adaptor kit. The pipe should be held firm (Fig.F)

*Place the threaded tap connector over the long part of the brass flange. Firmly push the flange into the other end of the water connector (Fig.G)

*Place the rubber washer inside the threaded tap connector and screw onto the water tap.

FINALLY: Plug in and switch on the electricity supply. Turn on the water supply tap. Check for any leaks. Ensure selection is set to ‘water’ (see page 15) push a cup under the dispenser to verify that water is flowing. When all working OK, move the appliance into its final location - your appliance is heavy and care should be taken when moving it, also do not trap or kink hoses at the back of the appliance. Replace the lower cover. Mount the water filter in an accessible position using the self-adhesive fixing plates and cable ties supplied.

9

Page 9
Image 9
Hotpoint FFU00 manual Installation, Connection of Water Filter