Installation
●FIRST CHECK YOU HAVE THE CORRECT
ITEMS:
-Pipe / Filter Kit comprises:
*1 x Water Filter
*2 x
*2 x Cable Ties
*1 x 10m Water Pipe
-Adaptor Kit comprises:
*Plastic Pipe Connector
*Rubber Washer
*Threaded Tap Connector
●NEXT, HAVE A LOOK AT THE DIAGRAM BELOW TO VISUALISE HOW THE APPLIANCE SHOULD BE CONNECTED:
Fridge
Water Pipe
Filter
Water Pipe Tap
●Connection to the Appliance:
*At the back of the appliance you will see the water inlet valve (Fig.A)
*Unscrew the metal threaded collar and place it over one end of the water pipe (Fig.B)
*Push the water pipe onto the water inlet valve firmly, tighten up the metal collar (Fig.C)
*You now need to cut the water pipe to the right length for the connection of the water filter.
It is suggested that approximately 1.5m of pipe is used - this should allow the filter to be located in an easily accessible position (as the water filter should be replaced approximately every 6 months, according to use and conditions) and also allow some slack in the pipe behind the appliance, so that it can be pulled out for cleaning or servicing purposes.
You must also ensure that the cut is square and not at any sort of angle as this could cause a leak.
✓
✗
8