Hotpoint FZ92P manual Troubleshooting, Check

Troubleshooting.

PROBLEM. . .	CHECK. . .
	1. Check plug is firmly positioned in wall
The appliance won’t work.	socket and the power supply is switched
	on.
None of the displays illuminate.	2. Check the power supply with another
	appliance.
	3. Check fuse.
	1. Check that the appliance is level.
	2. Is the appliance overloaded? Do Not
The appliance is making alot of noise.	exceed the Max. Freezer Capacity.
	2. Ensure rear pipework is clear of wall and
	skirting board.
	A well sealed freezer door can be difficult to
	open. This is partly due to the difference in
	temperature between the room and internal
The freezer door is difficult to open.	compartment. if you have just closed the
	freezer door, it may be particularly difficult to
	open immediately. Wait 5 minutes for the
	internal and external pressure to equalise and
	try again.
	It is too warm in the freezer compartment.
	Is there adequate air circulation? (see page 5)
	Check all temperature settings (see page 7)
	Have you observed maximum freezer
The Alarm Display (3) illuminates, the	capacity (see page 6)
warning tone sounds.	Has hot food recently been placed in the
	appliance?
	Is the air grille blocked?
	Press the Alarm Cancel button (7) to cancel
	the warning tone.
	The freezer compartment became too warm.
	Press the Alarm Cancel button (7) to stop the
There has been a power failure, the	display from flashing. The warmest tempera-
	ture reached in the freezer is displayed and
Temperature Display (2) is flashing.
	then clears. If it displays a temperature more
	than +3˚C, the food must be used or cooked
	and refrozen.
	The refrigerating unit in the No-Frost system is
	covered in so much ice that it can no longer
	defrost automatically...
	Remove all stored food, wrap and place in a
	cool location.
The freezer compartment door was	Switch off and unplug the appliance. Put a
	couple of bowls of hot water in baskets (on
left open for a long time and the
	heat resistant base) and close the door.
freezer compartment no longer
	Defrost water will go into the evaporation pan
reaches the selected temperature.
	at the rear of the appliance, sponge this
	several times to prevent overflowing.
	After about 1 hour, when all the defrost water
	has run into the evaporation pan, clean and
	thoroughly dry the interior, plug in and switch
	on.
The display shows "E1".	The electronics are defective, call for a
	Service Engineer.

10