Hotpoint GX901X X mm, Hobs installation, Installation above a built-in oven, Fixing to the unit

Installation

Hobs installation

Suitable precautions must be taken to ensure that the installation is in compliance with current accident- prevention regulations regarding electrical and gas connections.

For trouble-free operation of the appliance set into kitchen units, the minimum distances indicated in fig.3 should be complied with and the adjoining surfaces and rear wall should be capable of withstanding a surface tempe- rature of 65 °C.

Installation above a built-in oven

Both the electricity supply cable and the gas pipe must not touch hot parts of the oven housing, in order to avoid overheating.

Suitable air vents should be provided for as shown in fig.3 (inlet at least 200 cm² from the bottom, outlet at least 120 cm² from the top part) to allow adequate ventilation inside the housing unit.

Fixing to the unit

To fix the hob to the unit, proceed as follows (fig.4);

•tighten 2 screws “ A” (provided) into the unit, leaving the screw heads projecting 1.5 mm from the wood.

•hook the hob onto the 2 screws “ A” and push backwards.

•fix the hob to the unit at the rear using the 2 corner brackets “B” and the 4 screws “ C” provided.

fig.3

BC

Xmm

Xmm

1.5 mm

A

fig.4

9