Hotpoint HDA2600K The SYSTEMS MONI~R continued, Before you call for service, Display, What To Do

The SYSTEMS MONI~R (continued)

	DISPLAY	WHAT IT MENS	WHAT TO DO
		The water temperature in the	Avoid showers or laundry just prior to running the dishwasher.
		dishwasher did not reach the	(Use the “DELAY START” feature to start dishwasher
		proper wash temperature. This	when the water heater is up to normal temperature. ) Adjust
		is usually caused by lack of hot	household water heater thermostat to 120°F. minimum.
		water coming from the household	If C6 appears nearly every cycle and you know the water
		water heater.
			from the household water heater is hot (120°F. or more), call
			for service.
		The temperature sensor in the	The temperature sensor needs to be replacd. Call for service.
		dishwasher is not functioning	N~E:
		properly. Dishwasher may continue
			You may continue to use your dishwasher. For best results,
		to be used, but it will not heat
			adjust your household water heater thermostat to 140°F.
		water automatically.
#-#-/		The detergent cup did not open.	1. Unlatch and open the dishwasher door.
::-/		This is usually caused by a utensil	2. Check for utensils and dishes that could have blocked the
		or dish.
			detergent cup from opening. Rearrange if necessary.
			3. Close and relatch the door. Wait for 30 seconds. This will
			allow time for the cup to open by itself.
			4. If the detergent cup is still closed, open it by hand and
			remove the old detergent. See page 13.

Before you call for service

●Try the cycle again to see if the Code reappears. The dishwasher may correct itself.

●Electronic controls can be affected by outside interference.

. Sometimes shutting off the power to the dishwasher (at the fuse or circuit breaker) will correct the problem.

●Restore power after about five seconds and try the cycle again.

●Check the guide on pages 8-10 for things you can do to correct the problem.

10