•The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.
•All accessories - with the exception of the sliding racks
- can be washed like everyday crockery, and are even dishwasher safe.
•We recommend that detergents are not sprayed directly onto the control panel, but that a sponge is used instead.
!Never use steam cleaners or pressure cleaners on the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge and a
1.Open the oven door fully (see diagram).
2.Use a screwdriver to lift up and turn the small levers F located on the two hinges (see diagram).
F |
3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you, lifting it out of its slot (see diagram). To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.
Replacing the light bulb
!Do not use the oven lamp as/for ambient lighting.
GB
Automatic cleaning with the FAST CLEAN function
With the FAST CLEAN mode, the internal temperature of the oven reaches 500°C. The pyrolytic cycle is activated, burning away food and grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle as surfaces may become very hot. Particles may ignite inside the oven due to the combustion process. There is no cause for concern: this process is both normal and
Before initiating the FAST CLEAN mode:
•clean the oven door;
•remove large or coarse food residues from the inside of the oven using a damp sponge. Do not use detergents;
•remove all accessories and the sliding rack kit (where present);
•Do not place tea towels or pot holders over the oven handle.
•Turn the SELECTOR knob to the “0” position.
!If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to cool down.
!The programme may only be started once the oven door has been closed.
To activate the FAST CLEAN cycle press and hold the button for approximately 4 seconds. The TIMER KNOB may be used to select the desired cleaning level; there are three default time settings which cannot be modified.
1.Economy (ECO): turn the knob towards “ ”. Duration 1 hour.
2.Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3.Intensive (INT): turn the knob towards “”. Duration 2 hours.
4.Press the button to confirm.
An end time for the FAST CLEAN cycle (as for a normal cooking cycle) may be programmed (see Programming the automatic cleaning end time).
Safety devices
Lamp |
Holder |
compartment |
Lamp |
Glass cover |
To replace the oven light bulb:
1.Remove the glass cover of the
2.Remove the light bulb and replace it with a similar one: halogen lamp voltage 230 V, wattage 25 W, cap G 9.
3.Replace the glass cover (see diagram).
• | The | icon on the display, when lit, indicates that | |
| the oven door was automatically locked as soon as the | ||
| temperature reached a high value. |
| |
• | The | icon indicates that the cleaning cycle may | |
| be cancelled at any time by pressing the | button. | |
• | If a malfunction occurs, the heating elements will be | ||
| switched off. |
| |
• Once the oven door has been locked, you cannot change |
!Do not touch the light bulb directly with your hands.
the duration and cycle end time settings. |
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
11