Hotpoint RB757, RB756 Leveling The Range, Radiant Surface Units, Save These Instructions, Service

Models: RB757 RB754 RB755 RB756 LEB326 LEB356 LEB316 LEB327

1 32
Download 32 pages 29.38 Kb
Page 7
Image 7
LEVELING THE RANGE

LEVELING THE RANGE

Safety Instructions

Leveling screws are located on each corner of the base of the range. Remove the bottom drawer and you can level the range on an uneven floor with the use of a nutdriver.

To remove the drawer, pull the drawer out all the way, tilt up the front and take it out. To replace the drawer, insert glides at back of the drawer beyond stop on the range glides. Lift drawer if necessary to insert easily. Let the front of drawer down, then push in to close.

One of the rear leveling screws will engage the Anti-Tip device. Allow for some side to side adjustment. Allow a minimum clearance of 1/8″ between the range and the leveling screw that is to be installed into the Anti-Tip device.

Operating Instructions

RADIANT SURFACE UNITS

Use care when touching the cooktop. The glass surface of the cooktop will retain heat after the controls have been turned off.

Avoid scratching the glass cooktop. The cooktop can be scratched with items such as sharp instruments, rings or other jewelry and rivets on clothing.

Do not operate the radiant surface units if the glass is broken. Spillovers or cleaning solution may penetrate a broken cooktop and create a risk of electrical shock.

Contact a qualified technician immediately should your glass cooktop become broken.

Never use the glass cooktop surface as a cutting board.

Do not place or store items that can melt or catch fire on the glass cooktop, even when it is not being used.

Be careful when placing spoons or other stirring utensils on glass cooktop surface when it is in use. They may become hot and could cause burns.

Do not stand on the glass cooktop. The weight may cause the top to break.

Avoid heating an empty pan. Doing so may damage the cooktop and the pan.

Clean the cooktop with caution. If a wet sponge or cloth is used to wipe spills on a hot surface unit, be careful to avoid steam burns. Some cleaners can produce noxious fumes if applied to a hot surface.

NOTE: We recommend that you avoid wiping any surface unit areas until they have cooled and the indicator light has gone off. Sugar spills are the exception to this. Please see Cleaning the glass cooktop section.

When the cooktop is cool, use only the recommended cleaning cream to clean the cooktop.

To avoid possible damage to the cooking surface, do not apply cleaning cream to the glass surface when it is hot.

After cleaning, use a dry cloth or paper towel to remove all cleaning cream residue.

Read and follow all instructions and warnings on the cleaning cream labels.

Care and Cleaning Troubleshooting Tips Customer

Read and follow this Safety Information carefully.

SAVE THESE INSTRUCTIONS

7

Service

Page 7
Image 7
Hotpoint RB757 Leveling The Range, Radiant Surface Units, Read and follow this Safety Information carefully, Service