Description of the appliance
Control panel
Calibrating the control panel
When the plug is inserted (or after a blackout) the system calibrates the keys; during calibration the display point flashes. Calibration lasts 15”. The point stops flashing at the end of calibration.
Off/Stand by: the On condition is obtained by
pressing 
for 3 seconds; in this case keys 
and 
are enabled, the display point and the blue led of the relative keys light up. The Off condition is
obtained by pressing 
again for 3 seconds.
On/Off lights: press 
to switch on the lights, which turn amber. Contemporaneously the symbols at
the sides 
and 
turn blue: the intensity of the light can be increased and diminished with these.
Once the luminosity has been set, pressing 
rapidly again memorises it (the symbol turns blue) and the light
switches off.
On/Off motor: press 
to switch the motor on. It turns amber. Contemporaneously the symbols at the
sides 
and 
as well as 
turn blue.
Press 
or 
to adjust the intensity of
Fats filter signal: this symbol (red led) lights up
after 40 hours. Reset the signal by pressing 
for a long time (at least 3 seconds) until the beep confirms it.
Carbon filter signal action.
This signal is shown only if it has been previously set.
Proceed as follows: press 
with the hood in Off:
first 
turns red, after about 1 second 
also turns red. If you want to eliminate the carbon filter
signal previously set, press 
with the hood in Off. Reset the carbon filter signal (after 160 hours) by
pressing 
for a long time (about 3 seconds, until the beep).
suction. Pressing 
again switches the motor off and the last speed set is memorised.
Intensive timing: by pressing this key the suction of the hood becomes intensive for a maximum time of 5 minutes. At the end the hood returns to the speed previously set. To exit from the function earlier press
or one of the following keys: 
, 
or
.
