CHAPTER 2 – USING THE CONTROLS AND MODES
2.1SETTING THE CLOCK (for key references see page 5)
•When the appliance is connected to the domestic power supply for the first time, or after a power cut, four dashes will appear on the display
In order to set the clock, proceed as described below:
1 Press the 
key (6).
(The hours flash on display 1)
2 Set the desired time by turning the 
knob (14).
(The hours flash on display 1)
3 Press the 
key (6) again.
(The minutes flash on display 1)
4 Set the desired minutes by
turning the 
knob (14)
(The minutes flash on display 1)
5 Press the 
key (6) again.
(The display shows the time set)
•If you wish to change the hour on the dial once it has been set, press the 
key (6) before proceeding to set the new time as described above.
•It is possible to display the current time even after starting the mode set, by pressing the 
key (6) (the time is displayed for 2 seconds).
14
