Maintenance and care
Switchingtheapplianceoff
GB
Disconnect your appliance from the electricity supply before carrying out any work on it.
Cleaning the appliance
•The
•Ideally, the inside of the oven should be cleaned after each use, when it is still lukewarm. Use hot water and detergent, rinse and dry with a soft cloth. Do not use abrasive products.
•All accessories - with the exception of the sliding racks - can be washed like everyday crockery, and are even
Replacingthelightbulb
To replace the oven light bulb:
1.Remove the glass cover of the
light bulb and replace it with a similar one: Wattage 25 W, cap E 14.
3. Replace the glass cover (see diagram).
Sliding Rack Kit Assembly
To assemble the sliding racks:
dishwasher safe.
Never use steam cleaners or pressure cleaners on the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge and a
To clean more thoroughly, you can remove the oven door.
1.Open the oven door fully (see diagram).
2.Lift up and turn the small levers located on the two hinges (see diagram).
| A |
Left | Right guide |
guide rail | rail |
1.Remove the two frames, lifting them away from the spacers “A” (see figure).
2. Choose which shelf to |
use with the sliding rack. |
Paying attention to the |
direction in which the |
F |
B |
oDire | |
C |
|
f | c |
extra on | |
| ti |
| c |
| ti |
| on |
sliding rack is to be |
extracted, position joint B |
and then joint C on the |
frame. |
F |
3.Grip the door on the two external sides and close it approximately half way. Unlock the door by pressing on the clamps F, then pull the door towards you lifting it out of its seat (see diagram).
To replace the door, reverse this sequence.
3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.
Inspecting the seals
Check the door seals around the oven periodically. If the seals are damaged, please contact your nearest After- sales Service Centre (see Assistance). We recommend not using the oven until the seals have been replaced.
4. Finally, fit the frames on spacer A.
Do not place the sliding racks in position 5.
12