Hotpoint SY89PG manual Care and maintenance, Switching the appliance off, Cleaning the appliance

Care and maintenance

Switching the appliance off

GB

Disconnect your appliance from the electricity supply before carrying out any work on it.

Cleaning the appliance

3.Grip the door on the two external sides and close it approximately half way. Pull the door towards you, lifting it out of its slot (see diagram).

•	The stainless steel or enamel-coated external
	parts and the rubber seals may be cleaned using
	a sponge that has been soaked in lukewarm water
	and neutral soap. Use specialised products for
	the removal of stubborn stains. After cleaning,
	rinse and dry thoroughly. Do not use abrasive
	powders or corrosive substances.
•	The inside of the oven should ideally be cleaned
	after each use, while it is still lukewarm. Use hot
	water and detergent, then rinse well and dry with
	a soft cloth. Do not use abrasive products.

F

3.(With glass panel fitted to the inside of the door) Grip the door on the two external sides and close it approximately half way. Unlock the door by pressing on the clamps F, then pull the door towards you lifting it out of its seat (see diagram).

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

￿Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack. For more thorough cleaning purposes, the oven door may be removed:

1. Open the oven door fully

(see diagram).

2.Lift up and turn the small levers located on the two hinges (see diagram).

F

With glass panel fitted to the inside of the door

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven periodically. If the seals are damaged, please contact your nearest After-sales Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

Oven

compartment

Lamp

Seal

Glass door

1.Remove the glass cover using a screwdriver.

2.Unscrew the light bulb and replace it with a similar one: Wattage 15 W, cap E 14.

Replace the glass cover, making sure the seal is positioned correctly (see diagram).

10