Installation
2
REMOVE TRANSIT BRACKETS...
3 CONNECT TO TH
OUIMPORTANT:
Internal transit brackets are fitted to prevent damage during transit and MUST be removed before use...
Failure to do so may cause damage to your machine!
|
|
|
Remove and |
| From the rear of the |
| machine, grip sides of | |
retain 3 screws |
| |
| the worktop lid, lift, slide | |
from the back of |
| |
| and pull towards you. | |
the worktop lid |
| |
|
|
Slide and push worktop lid back into position, ensuring front edge is correctly located into the console.
|
|
|
|
|
Remove 4 screws |
| Remove 3 screws | ||
and the rear transit |
| and front transit | ||
bracket - retain. |
| bracket - retain. | ||
|
|
|
|
|
|
|
|
|
|
Replace the work top lid using the 3 original screws.
PLEASE USE THE NEW HOSES SUPPLIED, FITTED TO THE MACHINE.
DO NOT REMOVE!
Old hoses may cause leaks due to worn out washers.
DRAINAGE SYSTEM... we recommend one of the following:
TE: ALTHOUGH YOU MAY NEED TO OVE THE HOOKED END SUPPORT ONG THE GREY DRAINAGE HOSE,
DO NOT REMOVE IT.
HICHEVER DRAINAGE METHOD OU USE, MAKE SURE THAT THE OOKED END SUPPORT IS FIXED VEL TO, OR ABOVE THE ‘MINIMUM DRAINAGE HOSE HEIGHT LINE’*
ee Getting to Know your Appliance)
STANDPIPE METHOD
Hooked End Support
Insert drainage hose approximately 100mm into the standpipe.
.............................
Standpipe height: minimum 500mm from the floor.
OR
UNDER SINK METHOD
cut off the blocked end of the under sink drainage unit.
800mm from floor
Fix the hooked | Attach the GREY |
end support at | drainage hose to the |
a minimum | under sink drainage |
800mm from | unit securely, using a |
the floor. | hose clip. |
O FRONT FEET ARE S FIRM AND LEVEL. k and The Foot
ONLY the locking disk e two front feet until is up against the base e machine.
6
CONNECT TO THE POWER SUPPLY...
PLUG YOUR MACHINE INTO AN ELECTRICAL SOCKET WHICH IS EASILY ACCESSIBLE. SWITCH ON
NOTE: Hotpoint recommend extension leads are not used.
Move your machine into position, take care not to trap or kink the hoses.
7
READY...
TO CHECK ALL PARTS CLEAN THE INSIDE OF
SELECT A 95˚ WHITE
✗ WITH
THIS WILL TAKE A
