Hotpoint WD63, WD64 manual Washcare Tips, Electricity Supply, Drawer’

Models: WD64 WD63

1 12
Download 12 pages 39.53 Kb
Page 9
Image 9

STEP 8

Troubles

 

 

Washcare Tips:

Before washing:

Pre-treat stains.

Close zips, tie belts, strings etc...

and press studs to prevent tangling.

Remove papers or tissues from pockets.

Remove sharp objects and coins from pockets as they could cause damage to clothes or the appliance.

Limit the size of absorbent loads ie. towels, to 3kg (7lb) to give good washing/rinsing results.

Place small items in a wash bag.

Check wash labels as some items may require a cool programme.

Wash non-colourfast woollens or really dirty laundry separately as they may affect other items.

Laundry will not wash properly if you overload the appliance.

Laundry without a wash label should not be machine washed.

MY MACHINE MAKES A

NOISE OR VIBRATES IN A

SPIN PROGRAMME.

Check all loose items, such as

coins, have been removed

from the laundry.

Have both transit fixings been removed from the machine?

Has the polystyrene block been removed from underneath the machine?

Have you adjusted the feet to

stabilise the machine?

See STEP 2: Installation

MY LAUNDRY HAS NOT

SPUN DRY.

Was a short spin programme

used on a non-synthetic load.

 

There has been an

unbalanced load and the machine could not spin. Redistribute the clothes by hand and select a spin only programme.

Did the water pump out?

If not see ‘MY MACHINE DOES

NOT PUMP OUT WATER’.

MY MACHINE WILL NOT

START

Close the door. Choose a

programme and then press ‘ON’

Does the ‘door indicator’ light

come on after 2 seconds?

Is the machine plugged in

and switched on?

Is the socket OK? Test with another appliance to check.

Is the fuse in the plug OK?

Plug the machine in and turn the socket switch on.

If possible use another socket

for the machine.

If not replace it, see STEP 1:

Electricity Supply

MY MACHINE STOPS

BEFORE A SPIN

PROGRAMME.

The ‘Rinse Hold’ button has been pressed, this will hold laundry in the final rinse water, until the button is pressed again.

MY MACHINE DOE

PUMP OUT WA

Has the drain hose bee correctly?

Are the drainage unit, or under sink connec from blockage

Has ‘Rinse Hold’ been

The light will flash until is pressed aga

Press the ‘Rinse Hold again.

See STEP 2: Install

Clear any blockages t been found

Is the machine conn a sink waste syst

Check the blocked en under sink drainage been cut off.

WATER COLLECTS

FABRIC DISPEN

COMPARTME

Clean fabric dispense

See STEP 3:‘The Dis

Drawer’.

Page 9
Image 9
Hotpoint WD63, WD64 manual Washcare Tips, Electricity Supply, Drawer’