![](/images/new-backgrounds/1241668/24166847x1.webp)
22CHAPTER 2: HARDWARE INSTALLATION
You should leave the Authentication Method as its default: Auto if your
ISP doesn’t specify this parameter.
If your ISP allocates fixed or static IP information, you need the following information:
IP Address | : ____.____.____.____ |
Subnet Mask | : ____.____.____.____ |
Default Router address | : ____.____.____.____ |
DNS address | : ____.____.____.____ |
| If your ISP allocates IP information dynamically over a protocol other |
| than PPPoE, you do not need any further information. This configuration |
| is typical of cable connections. |
|
|
Powering Up the | To power up the Router: |
Router |
|
1 | Plug the power adapter into the power adapter socket located on the |
| back panel of the Router. |
2 | Plug the power adapter into a standard electrical wall socket. |