HP 2311cm/2311f/2311x, 2211f/2211x, 2511x, 2011x/2011s manual Identifying Monitor Conditions

Icon	Main Menu Options	Sub-menu Options	Description
		Auto-Switch Source	Turns the automatic video signal input to
			On or Off on the system. The factory
			default is On.
	Exit		Exits the OSD menu screen.

Identifying Monitor Conditions

Special messages appear on the monitor screen for the following monitor conditions:

●Monitor Status — When the monitor is powered on or when the input source signal is changed, a Monitor Status message is displayed for five seconds. The message shows which input is the current active signal, the status of the auto-switch source setting (On or Off), the default source signal, the current preset display resolution, and the recommended preset display resolution.

●Input Signal Out of Range — Indicates the monitor does not support the input signal on the video card, because its resolution or refresh rate is set higher than the monitor supports.

Change your video card settings to a lower resolution or refresh rate. Restart your computer for the new settings to take effect.

●Power Button Lockout — Indicates the power button is locked. If the power button is locked, the warning message Power Button Lockout appears.

◦If the power button is locked, press and hold the power button for 10 seconds to unlock the power button function.

◦If the power button is unlocked, press and hold the power button for 10 seconds to lock out the power button function.

●Monitor Going to Sleep — Indicates the screen display is entering a sleep mode.

●Check Video Cable — Indicates a video input cable is not properly connected to the computer or monitor.

●OSD Lockout — The OSD can be enabled or disabled by pressing and holding the Menu button on the front panel for 10 seconds. If the OSD is locked, the warning message OSD Lockout appears for 10 seconds.

◦If the OSD is locked, press and hold the Menu button for 10 seconds to unlock the OSD.

◦If the OSD is unlocked, press and hold the Menu button for 10 seconds to lock the OSD.

●Dynamic Contrast Ratio ON – Indicates that DCR is turned on.

●Dynamic Contrast Ratio OFF – Indicates that DCR has been turned off in the OSD or was automatically turned off after changes were made to Brightness or Quick View in the OSD.

●No Input Signal — Indicates the monitor is not receiving a video signal from the computer on the monitor video input connector. Check to see if the computer or input signal source is off or in the power-saver mode.

24 Chapter 4 Operating the Monitor ENWW