install the software and connect the scanner

install the software first (Windows and Macintosh)

Set up your scanner in one of two ways: either install the software first or connect the scanner first. It is recommended that you install the software first, especially on a Macintosh computer.

If you experience difficulty installing your scanner, see installation problems - hp scanjet 2300c or 3500c series on page 11.

1Close all open programs on your computer.

2Locate the HP Photo & Imaging software CD-ROM that is appropriate for your language and operating system and insert it into your computer.

3For a Microsoft Windows computer: Follow the instructions on the screen. Or, if the installation program does not start automatically:

a.On the Start menu, click Run.

b.Type: x:setup.exe (where x is the letter of the CD-ROM drive).

For a Macintosh computer (HP Scanjet 3500c series only): Double-click the Installation Read Me file on the CD-ROM and follow the instructions.

4If the instructions prompt you to shut down your computer, do so.

5Connect the USB cable between the USB port on the scanner and the USB port on the computer.

6Connect the power cable between the scanner and a surge protector or a grounded wall outlet that is easy to reach. This turns on the scanner.

7If necessary, turn your computer on again.

connect the scanner first (Windows only)

connect USB cable to scanner

connect USB cable to computer

1Make sure that your computer is on and that the operating system is running.

2Connect the USB cable between the USB port on the scanner and the USB port on the computer.

install the scanner

2