Note

This section applies only to HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500 models.

Required Equipment

•#0 Phillips screwdriver.

Removal Procedure

1.Unplug the AC adapter, if present, and remove the battery.

2.Remove these additional assemblies:

•Hard disk drive (page 2-9).

•Keyboard cover (page 2-12).

•Keyboard (page 2-16).

•Switchboard PCA (page 2-18).

•Display assembly (page 2-23).

•Top case (page 2-26).

3.Disconnect the two fan cables from the motherboard.

4.Remove the four retaining M2.0×5.0 mm screws in the “1”, “2”, “3”, “4” sequence stamped on the heat sink.

5.Lift up on the heat sink (with fan).

Figure 2-27. Removing the Heat Sink (with Fan)

HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500 Models

2-42 Removal and Replacement

Service Manual