HP 311c-1070EF manual Wwan module

Removal and replacement procedures

WWAN module

Description	Spare part number
HSPA EV-DO WWAN module for use with the HP Mini and Compaq Mini in all countries and regions	483377-002
except the People’s Republic of China
HSPA EV-DO WWAN module for use with the HP Mini and Compaq Mini in the People’s Republic	483377-003
of China
UNDP HSPA EV-DO WWAN mini module	531993-001

Before removing the WWAN module, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer.

4.Remove the battery (see “Battery” on page 4-7).

5.Remove the accessory compartment cover (see “WLAN module” on page 4-9).

Remove the WWAN module:

ÄCAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module authorized for use in the computer by the governmental agency that regulates wireless devices in your country or region. If you replace the module and then receive a warning message, remove the module to restore computer functionality, and then contact technical support through Help and Support.

1.Position the computer with the front toward you.

2.Disconnect the WWAN antenna cables 1 from the terminals on the WWAN module.

✎The red WWAN antenna cable is connected to the WWAN module “Main” terminal. The blue WWAN antenna cable is connected to the WWAN module “Aux” terminal.

3.Remove the 2 Phillips PM2.0×4.0 screws 2 that secure the WWAN module to the system board. (The WWAN module tilts up.)

4.Remove the WWAN module 3 by pulling it away from the slot at an angle.

✎WWAN modules are designed with a notch 4 to prevent incorrect insertion of the WWAN module into the WWAN module slot.

Maintenance and Service Guide 4–13