Message

Found Plug and Play ISA card: Plug and Play ISA Card Name.

Probable Cause

Corrective Action

 

 

 

 

This message appears

Status message; no action is required.

at system start-up for

 

each Plug and Play

 

ISA expansion card

 

recognized by the

 

Configuration Manager.

 

 

 

NOTICE: Boot Device Not

Active! CSN=Card Select

Number.

One or more active devices have been reconfigured - system requires reboot. Press any key to reboot system.

The Plug and Play ISA card has been successfully configured.

Card Count Plug and Play ISA cards have been successfully configured.

A boot device was found to be inactive.

You modified the resource values of one or more PCI or Plug and Play ISA expansion cards.

The Configuration Manager ha successfully configured the given number of cards.

Status message; no action is required. The Configuration Manager automatically configures and activates the device.

Reboot the system to reconfigure the card(s).

If this message does not match the number of Plug and Play ISA expansion cards installed in your computer, reinstall any Plug and Play expansion cards not listed and reboot the system.

ERROR: Insufficient CM

There is not enough

Memory

memory available to

 

the Configuration

 

Manager for it to run.

 

 

 

 

ERROR: Fatal BIOS

A BIOS call failed with

error Internal Error Code.

an internal error. The

 

most likely cause is an

 

incompatibility between

 

the BIOS and the

 

Configuration Manager.

 

 

Disable any TSR programs or any unneeded device drivers.

See the chapter titled "Getting Help" in your Diagnostics and Troubleshooting Guide for instructions on obtaining technical assistance.

ERROR: Could not read NVS, Error=Internal Error Code.

ERROR: Failed NVS write. Error=Internal Error Code.

ERROR: Failed to activate device, CSN=Card Select Number.

An attempt to read the NVRAM failed.

An attempt to write to NVRAM failed.

A Plug and Play expansion card could not be activated.

See the chapter titled "Getting Help" in your Diagnostics and Troubleshooting Guide for instructions on obtaining technical assistance.

Run the Dell Diagnostics to verify the integrity of your system NVRAM. See the chapter titled "Running the Dell Diagnostics" in your Diagnostics and Troubleshooting Guide for instructions. If you are unable to determine the cause of the error, see the chapter titled "Getting Help" in your Diagnostics and Troubleshooting Guide for instructions on obtaining technical assistance.

Use the following procedure:

1.Exit the ICU and turn off your system.

2.Remove the Plug and Play expansion card that could not be activated.

Follow steps 2 through 5 of "Removing an Expansion Card" and then return to this procedure.

3.Reinstall the Plug and Play expansion card.

Follow steps 4 through 8 of "Installing an Expansion Card" and then return to this procedure.