3.Rotate the drive cage to its upright position.

4.If removing an optical drive, disconnect the power cable and data cable from the rear of the optical drive.

CAUTION: When removing the cables, pull the tab or connector instead of the cable itself to avoid damaging the cable.

5.Rotate the drive cage back down to its normal position.

CAUTION: Be careful not to pinch any cables or wires when rotating the drive cage down.

6.Press down on the green drive retainer button located on the left side of the drive to disengage the drive from the drive cage (1). While pressing the drive retainer button, slide the drive back until it stops, then lift it up and out of the drive cage (2).

Figure 8-16Removing the 5.25-inch Drive

Installing a 5.25-inch Drive into a Drive Bay

1.Prepare the computer for disassembly (Preparation for Disassembly on page 163).

2.Remove the access panel (Access Panel on page 164).

3.If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove the bezel blank. See Bezel Blanks on page 168 for more information.

Drives 181