Some networks change the SSID or network keys used in their routers or access points on a regular basis to improve security. You must change the corresponding code in your computer accordingly.

If you are provided with new wireless network keys and SSID for a network, and if you have previously connected to that network, follow the steps below to connect to the network:

1.Select Start > Control Panel > Network and Internet > Network and Sharing Center.

2.In the left panel, click Manage wireless networks.

A list showing the available WLANs is displayed. If you are in a hotspot where several WLANs are active, several will be displayed.

3.Select the network in the list, right-click the network, and then click Properties.

NOTE: If the network you want is not listed, check with the network administrator to be sure that the router or access point is operating.

4.Click the Security tab and enter the correct wireless encryption data into the Network security key box.

5.Click OK to save these settings.

WLAN connection is very weak

If the connection is very weak, or if your computer cannot make a connection to a WLAN, minimize interference from other devices, as follows:

Move your computer closer to the wireless router or access point.

Temporarily disconnect wireless devices such as a microwave, cordless phone, or cellular phone to be sure that other wireless devices are not interfering.

If the connection does not improve, try forcing the device to reestablish all connection values:

1.Select Start > Control Panel > Network and Internet > Network and Sharing Center.

2.In the left panel, click Manage wireless networks.

A list showing the available WLANs is displayed. If you are in a hotspot where several WLANs are active, several will be displayed.

3.Click a network, and then click Remove.

Cannot connect to the wireless router

If you are trying to connect to the wireless router and are unsuccessful, reset the wireless router by removing power from the router for 10 to 15 seconds.

If the computer still cannot make a connection to a WLAN, restart the wireless router. For details, see the router manufacturer's instructions.

Network status icon is not displayed

If the network status icon is not displayed in the notification area after you configure the WLAN, the software driver is either missing or corrupted. A Windows “Device not Found” error message may also be displayed. The driver must be reinstalled.

Get the latest version of the WLAN device software and drivers for your computer from the HP website at http://www.hp.com. If the WLAN device you are using was purchased separately, consult the manufacturer's website for the latest software.

72 Chapter 13 Troubleshooting and support