HP Bluetooth Stereo Headphones Installing the Headphones Driver, Pairing the Headphones with a Pocket

Installing the Headphones Driver

1.Perform a soft reset on your HP iPAQ Pocket PC by pressing the Reset button on the back or bottom of the device. For more information on performing a soft reset, refer to the User’s Guide that came with your HP iPAQ Pocket PC.

2.Backup your iPAQ Pocket PC using ActiveSync before installing the Headphones driver.

3.If the Bluetooth Radio on your Pocket PC is on, turn it off.

4.Establish a connection from your iPAQ Pocket PC to your desktop computer via ActiveSync. Refer to the User’s Guide that came with your iPAQ Pocket PC for instructions.

5.Place the CD that came with your HP iPAQ Bluetooth Stereo Headphones into an optical drive on your computer.

6.Click the button that reads “Click Here to Install Software” and follow the instructions on your screen. If asked to reset your Pocket PC, tap Reset Now.

7.Once the unit is reset, the driver is installed.

Pairing the Headphones with a Pocket

PC

Before you can use the HP iPAQ Bluetooth Stereo Headphones, you must first pair them with an iPAQ Pocket PC with Bluetooth. To pair your headphones to a Pocket PC:

1.Make sure the batteries are charged on both the headphones and the HP iPAQ Pocket PC.

2.Make sure the headphones are turned off by pressing the Multi Function button in the center of the right earpiece of the headphones for about three seconds until the light flashes red and goes off.

HP iPAQ Bluetooth Stereo Headphones User’s Guide 4