(continued)

Parameter

Description

 

 

 

Note You will need to know this URL when you try to access the

 

Embedded Web Server.

 

 

Firmware

The internal networking component and device firmware revision

Revision

code.

 

Note If you call HP Support, depending on the problem, you might

 

be asked to provide the firmware revision code.

 

 

Hostname

The TCP/IP name assigned by the installation software to the device.

 

By default, this is the letters HP followed by the last 6 digits of the

 

Media Access Control (MAC) address.

 

 

Admin

Status of the administrator's password for the Embedded Web

Password

Server:

 

Set: Password is specified. You must enter the password to

 

make changes to the Embedded Web Server parameters.

 

Not Set: No password is set. A password is not required for

 

making changes to the Embedded Web Server parameters.

 

 

mDNS

Some local and ad hoc networks do not use central DNS servers.

 

They use a DNS alternative called mDNS.

 

With mDNS, your computer can find and use any HP All-in-One

 

connected to your local area network. It can also work with any other

 

Ethernet-enabled device that appears on the network.

 

 

Wired (802.3) network settings

The following table describes the 802.3 wired settings shown on the network configuration page.

Parameter

Description

 

 

Hardware

The Media Access Control (MAC) address that identifies the HP All-

Address (MAC)

in-One. This is a unique 12-digit identification number assigned to

 

networking hardware for identification, including routers, switches,

 

and other such devices. No two pieces of hardware have the same

 

MAC address.

 

Note Some Internet service providers (ISPs) require that you

 

register the MAC address of the Network Card or LAN Adapter that

 

was connected to your cable or DSL modem during installation.

 

 

IP Address

This address uniquely identifies the device on the network. IP

 

addresses are assigned dynamically through DHCP or AutoIP. You

 

can also set up a static IP address, though this is not recommended.

 

Caution Be careful when manually assigning an IP address. An

 

invalid IP address during installation will prevent your network

 

components from seeing the HP All-in-One.

 

 

setup Network

Basics Guide

27