HP CQ41-210AU, CQ41-206AU, CQ41-205AX, CQ41-204AU, CQ41-206AX Fan/heat sink assembly or heat sink

Removal and replacement procedures

Fan/heat sink assembly or heat sink

Description	Spare part number
Fan/heat sink assembly for models with discrete graphics subsystems (includes thermal material)	575283-001
Heat sink for models with UMA graphics subsystems (includes thermal material)	575284-001

✎To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the left side of the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature sensor and is designed to turn on automatically when high temperature conditions exist. These conditions are affected by high external temperatures, system power consumption, power management/battery conservation configurations, battery fast charging, and software requirements. Exhaust air is displaced through the ventilation grill located on the left side of the computer.

Before removing the heat sink (for models with UMA graphics subsystems) or the fan/heat sink assembly (for models with discrete graphics subsystems) follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the battery (see “Battery” on page 4-7).

5.Remove the following components:

a.Hard drive (see “Hard drive” on page 4-8)

b.Memory module (see “Memory module” on page 4-10)

c.RTC battery (see “RTC battery” on page 4-12)

d.WLAN module (see “WLAN module” on page 4-14)

e.Optical drive (see “Optical drive” on page 4-20)

f.Keyboard (see “Keyboard” on page 4-21)

g.Keyboard cover (see “Keyboard cover” on page 4-24)

h.Speaker assembly (see “Speaker assembly” on page 4-26)

i.Display assembly (see “Display assembly” on page 4-28)

j.Top cover (see “Top cover” on page 4-36)

k.System board (see “System board” on page 4-48)

4–52 Maintenance and Service Guide