Step 2: Check the option switch value (Sun systems only)
Only read this section if you are installing your autoloader into a Sun workstation system running Solaris version 2.6 or below. Go to step 3 if you are using your autoloader on a UNIX system, or straight to step 4 if you are using your autoloader on a Windows PC system.
The option switch setting is used to configure the autoloader for specific systems. The default of 7 is correct for most systems and is only changed for Sun workstations or servers running Solaris v. 2.6 or below.
| System | Value |
|
|
Default, | 7 |
later |
|
Sun Solaris v. 2.6 or below (workstations/servers running later versions of Solaris | 5 |
use the default of 7) |
|
|
|
1Check that the autoloader option switch (right switch on figure 4) is set to the correct value, as shown in the above table. Only change the switch value to 5 for Sun workstations running Solaris v. 2.6 or below.
2If the option switch is not set to the correct value for your system, change the configuration switches located on the back of the drive from the default settings, as shown in figure 4.
13