Understanding the OAR LED
The amber Operator Attention Required LED indicates warning conditions, as described in the following table:
LED display | Meaning | |
|
| |
On | A serious hardware error has occurred. | |
| • If you have just installed the autoloader, check the installation | |
|
| for loose connections and repeat the |
|
| power cables may not be connected. (An autoloader requires |
|
| two power connections: one for the autoloader and one for |
|
| the robotics.) If this is the problem, the front panel message is |
|
| Coms Error. |
| • Run HP Library & Tape Tools to determine what the problem is. | |
| • | If the fault condition persists, write down the message |
|
| displayed on the front panel and call for service. |
Fast flashing (four times per | A firmware upgrade is taking place. | |
second) |
|
|
Medium flashing (twice per | • | The tape cartridge is wearing out and should be replaced. |
second) |
| The "Worn Media" message will be displayed in this case. |
|
| Copy any data you wish to keep onto a new cartridge and |
|
| discard the old cartridge. |
| • The tape heads need cleaning. The "Clean Me" message will | |
|
| be displayed in this case. |
Slow flashing | • | The front panel door is open when it should not be. The "Close |
|
| Door" message will be displayed in this case. |
| • | There is a cartridge in the autoloader, but no magazine is |
|
| present. The "Stray Tape" message will be displayed in this |
|
| case. Load an empty magazine to retrieve the cartridge. |
| • | A hard fault condition has occurred. The message displayed |
|
| will give information about the type of error. Look up the |
|
| message in the electronic User’s Guide on the |
|
| HP StorageWorks Tape |
43