HP DAT autoloader DAT 72x6e Testing after installation, Do drivers need to be installed and, if so, which ones, The server does not reboot after installation, the required drivers.)

Do drivers need to be installed and, if so, which ones

Description	Further information
It is unclear whether there is a need to	Detailed information specific to your system can be
install drivers onto the system, and more	found on the www.hp.com/go/connect web site.
help is required.	Windows drivers can be obtained from the
	HP StorageWorks Tape CD-ROM or from
	www.hp.com/support. For support on UNIX
	systems, see the UNIX Configuration Guide on the
	HP StorageWorks Tape CD-ROM.
	(Backup software that states support for
	HP StorageWorks DAT autoloaders also provides
	the required drivers.)
The required drivers do not appear to be	Future drivers will be provided via the support web
available.	site when they become available.

Testing after installation

Remember that the system recognizes devices during boot-up. If you swap or connect a product when your system is running, you will need to reboot the system. Rebooting the system will reset devices and will often resolve problems. It is good practice to reboot every time you add a driver or install firmware.

Caution Never power off the drive during a firmware upgrade.

The server does not reboot after installation

Possible reason	Recommended action
You have installed an additional SCSI host	Remove the new host bus adapter and check the
bus adapter and its resources are clashing	server documentation.
with an existing adapter.
You have disconnected the power or SCSI	Check that the cables to all devices are firmly
cable from the server’s boot disk during the	connected.
drive installation process.

41