|
| Detailed Hardware Installation and Initial Setup Steps | |
|
| Overview | |
|
|
|
|
C a u t i o n |
| Make sure the air flow is not restricted around the sides and back of the DCM | |
|
| Controller. | |
|
| 5. Connect the DCM Controller to a Power Source | |
|
| ||
|
| Plug the included power cord into the DCM Controller’s power connector on | |
|
| the back panel and into a nearby AC power source. | |
|
|
|
|
|
|
|
|
Figure 2-2. DCM Controller, Rear View with Power Plug
6. Connect the Network Cable
Connect a network cable from a network device or patch panel to port 1 on the front of the DCM Controller. (For information about the type of network cable you should use, see Table
Figure 2-3. DCM Controller Front Panel Port Connections
7. Configure the IP Settings
Before you can access the DCM Controller’s Web browser interface, you must assign it an IP address and define its default gateway. Table