3 Connecting to a Windows NT Server 3.51

Windows for Workgroups Version 3.11

Windows for Workgroups Version 3.11

3 Connecting to a Windows NT Server 3.51

Requirements

•HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.

•Intel EtherExpress ISA 10MBS Ethernet adapter card and drivers disk Ver. 2.3.

•DriverName:Elnk3.SYS Size:27KB Date:7/18/96

•Microsoft Windows NT server 3.51 machine that supports Net BEUI, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

•

I/O Address

350 - 35Fh

•

Interrupt

IRQ 10

•

Board Connector type

Auto-detect

•

Force 8-bit operation

Yes

•

Flash chip address

Disabled

•

Remote boot program

None

Procedure

1With the HP Vectra turned off, install the Intel EtherExpress PRO ISA Ethernet adapter card into an ISA slot.

2Connect network Cable Media to the Intel EtherExpress card.

3Power on the machine.

4After booting, insert the Intel EtherExpress drivers disk Ver. 2.3.”, and execute “A:\SOFTSET2.EXE.”

5Select “Change Adapter configuration” and verify the resource settings listed above under the heading “Device Configuration.”

6If changes are required, save those changes and exit.

7Remove the Intel Drivers diskette and reboot the machine.