HP Ether Express Pro/10 +ISA LA8205B manual Windows NT Workstation Version Requirements

4Connecting to a Windows NT Server 4.0 Windows NT Workstation Version 3.51

Windows NT

Workstation

Version 3.51

Requirements

•HP Vectra with Microsoft Windows NT Workstation 3.51 installed.

•Intel EtherExpress PRO ISA Ethernet card and drivers disk Ver. 2.3. DriverName:EPRO.SYS Size:107KB Date:7/18/96

•Microsoft Windows NT Workstation 3.51 and Service Pack Media.

•Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/ IP,NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

•	I/O Address	350 - 35Fh
•	Interrupt	IRQ 10
•	Board Connector type	Auto-detect
•	Force 8-bit operation	Yes
•	Flash chip address	Disabled
•	Remote boot program	None

Procedure

1With the HP Vectra turned off, install the Intel EtherExpress PRO ISA Ethernet adapter card into an ISA slot.

2Connect network cable media to the Intel EtherExpress PRO ISA ethernet adapter card.

3Insert a DOS bootable diskette and power on the machine.

4After booting, insert the Intel EtherExpress drivers disk Ver. 2.3.” and execute “A:\SOFTSET2.EXE.”

5Select “Change Adapter configuration” and verify the resource settings listed above under the heading “Device Configuration.”

6If changes are required, save those changes and exit.

7Remove the Intel drivers diskette and reboot the machine.

8After windows loads, go to the “MAIN” program group , and double-click on “Control Panel.”

9Select the “Network” icon, and click “YES” to install NT networking.