HP Ether Express Pro/10 +ISA LA8205B manual Connecting to a Netware 4.11 Server

2 Connecting to a Netware 4.11 Server

Windows for Workgroups Version 3.11

Windows for Workgroups Version 3.11

2 Connecting to a Netware 4.11 Server

Requirements

•HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.

•Intel EtherExpress ISA 10MBS Ethernet adapter card and drivers disk Ver. 2.3.

•DriverName:EPRO.386 Size:16KB Date:10/22/96

•Novell Netware 4.11 server that supports Net BEUI, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

•Netware Client for DOS and MS Windows

Device Configuration

•	I/O Address	350 - 35Fh
•	Interrupt	IRQ 10
•	Board Connector type	Auto-detect
•	Force 8-bit operation	Yes
•	Flash chip address	Disabled
•	Remote boot program	None

Procedure

1With the HP Vectra turned off, install the Intel EtherExpress PRO ISA Ethernet adapter card into an ISA slot.

2Connect network cable media to the Intel EtherExpress card.

3Power on the machine.

4After booting, insert the Intel EtherExpress drivers disk Ver. 2.3.”, and execute “A:\SOFTSET2.EXE.”

5Select “Change Adapter configuration” and verify the resource settings listed above under the heading “Device Configuration.”

6If changes are required, save those changes and exit.