Chapter 1
Note Check the model number on the scanner lid. The steps below are for the HP Scanjet G4010. If you are using an HP Scanjet G4050, see Scan positives (such as 35 mm slides) or negatives — HP Scanjet G4050.
1.Open the scanner lid and remove the TMA cover by pulling the cover up.
2.Remove the negative strip holder from the slide holder.
3.Do one of the following to load the slides or negatives:
–If you are scanning slides, place the slides into the slide holder. Insert the slides with the top of the slides pointing up and with the front of the slides facing you. Make sure that the slides are flat and do not overlap.
–If you are scanning negatives, do the following:
a.Slide a negative strip with up to six frames into the negative strip holder so that the shiny side of the negative faces you. Negatives are easily damaged, so you should touch them only on their edges.
10 | HP Scanjet G4000 series |
