7Press Select to print the configuration page.
The configuration page shows the printer’s current configuration.
An HP JetDirect network configuration page will also print for networked printers and mopiers.
A configuration summary prints. On the first page of the printout, under Installed Personalities and Options, check for “IR POD
The HP Fast InfraRed Receiver can be placed on a table or attached to the side of the printer using the Velcro fasteners shown in Figure 3 on page 7.
To attach the HP Fast InfraRed Receiver on the side of the printer, continue with steps 1 and 2.
1Attach one Velcro faster to the round depression on the underside of the HP Fast InfraRed Receiver (see Figure 3).
2Attach the remaining Velcro fastener to the side of the printer (see Figure 3).
When the HP Fast InfraRed Receiver is situated on the printer, it should be close to the printer’s front edge as shown in Figure 4. This location allows for the largest possible area in which the portable computer’s IR port can operate. The required alignment of devices is described in “Executing the Print Job” on page 10.
6 HP Fast InfraRed Receiver | EN |