Connecting the MultiProbe Control Card to an Oscilloscope
PCI_MUL.DUT and PCI.ADP from your PCI Scope Preprocessor diskette to that directory.
3.Access the configuration menu of the MultiProbe Control card.
4.Select POD setup for the POD that will be connected to the Scope Preprocessor.
5.On the next menu select #2 Specify POD adapter and then select the file PCI.ADP and select proceed.
6.Return to the MultiProbe Configuration menu and Select Assign Signal Names
7.From the File selection menu select the MULTIPRB directory on the hard disk.
6. Select the field next to File.
Select the file PCI_MUL.DUT
7. Load the file
With PCI_MUL displayed in the File field, select Load File.
Once you have completed loading these two files the PCI Scope Preprocessor is ready for PCI analog analysis and the configured POD in the MultiProbe configuration menu will appear as below
For further information on the operation of the MultiProbe Control Card refer to the HP 16535A MultiProbe Users Guide.
The operation of the PCI Scope Preprocessor is independent of the Oscilloscope that is attached to the MultiProbe Control Card. Refer to the HP 16535A MultiProbe Control Users Guide for information on how to attach to the Oscilloscope.
10
