Acquiring signals with an Oscilloscope
Using an HP16534A oscilloscope
If you are using an HP 16534A oscilloscope, then follow this procedure.
1. Access the oscilloscope menus.
To view your measurements with an HP16534A oscilloscope, you need to exit the MultiProbe Control menus, then enter the oscilloscope menus. Select the MultiProbe field, then select the oscilloscope module.
2.Use the oscilloscope controls to run and adjust the measurement.
If you need help, refer to the documentation on your oscilloscope.
3. Select new signals.
You can select signals from the oscilloscope Select Signals field, the oscilloscope Scroll Signal field, or the MultiProbe Select Signal menu. Selecting signals from the oscilloscope menus is possible only with the HP16534A Oscilloscope.
A scope picture taken with the PCI Scope Preprocessor of a glitch with FRAME# and the PCI clock appears below.
13
