HP LaserJet 5Si 8000 Series Maintenance Kit Instructions Page 1
LJ
1 HP
8HP
1HP
WARNING, Turn the printer off, unplug it, and allow it to sit for 30 minutes before performing maintenance procedures.
Fuser Removal:
1.Open the left side door. If duplex unit is installed, remove it by pushing down on the green release lever and pulling it towards you and out of the printer.
2.Locate the fuser’s left and right blue locking levers. Turn each one downwards 90 degrees to unlock the fuser.
3.Grab the handles on the far left and right side of the fuser. Lift up slightly and pull it towards you until it is out of the printer.
Fuser Installation:
1.With the blue locking levers facing downward, slide the new fuser into the printer and drop it into place.
2.Turn the blue locking levers upward 90 degrees until they snap into place.
3.Reinstall the duplex unit if it was removed in step 1.
Feed/Separation Roller Removal & Replacement:
1.Pull tray 2 open until it stops.
2.Lift the front of the tray up and pull it towards you. It may be necessary to shake it slightly to release the tray from the printer. Do the same with tray 3.
3.Locate the four feed/separation rollers with the blue hub inside the printer (Two for tray 2, and two for tray 3). Pinch the tabs together and pull the rollers off of the shafts.
4.Remove the four new feed/separation rollers from the bag. Install the new rollers by sliding them onto each shaft until they snap into place. It may be necessary to turn them while doing this.
